Boards

At present, three different versions of STorM32-BGC boards are around.

Comments:

• The boards can in principle be populated with different microcontrollers; below the "typical" configuration is mentioned.
• To avoid confusion/missunderstandings please note: The boards provide many features hardware-wise, but not all are however currently supported by the firmware.

STorM32-BGC v1.2

STorM32 BGC board v1.2 with motor drivers in DFN package

MCU: STM32F103RC motor drivers: TC4452VMF on-board Bluetooth (optional) on-board 6DOF IMU (MPU6050) IR led Futaba S-Bus Spektrum satellite up to seven PWM/Sum-PPM inputs/outputs joystick for each axis additional I2C port (I2C#2) 2 auxiliary ports BUT port

supply voltage: 6 - 18 V or 2 - 4S motor current: max. 1.5 A per motor comment: this is not yet fully exploited and depends also on the motor driver package (SOIC or DFN); for DFN packages, motors with resistances of 15 Ohm or larger have been tested to be easily handled at 4S, it is expected that also motors with 10 Ohm or larger are handled well (for more details see here).

STorM32-BGC v1.1

STorM32 BGC board v1.1 with motor drivers in SOIC package

Differences to the v1.2 board:

• no Futaba S-bus support
• Spektrum satellite is supported, but no extra Spektrum connector on board
• no extra USB voltage protection diode

Comment: The order of pins on the I2C#2 port is reversed to that on the I2C#1 port; please consider this then connecting an MPU module to this port.

STorM32-BGC v0.17/v1.0

Differences to the v1.2 board:

• MCU: STM32F103RB
• motor drivers: only TC4452VAO in SO08 package
• no IR led support
• only three PWM/Sum-PPM inputs/outputs
• no Futaba S-bus support
• Spektrum satellite can be supported, but no extra Spektrum connector on board
• no additional I2C port
• no reverse voltage protection on the v0.17 board
• pin assignment on RC port different

Comment: The location of the pins needed to flash the firmware via an USB-TTL adapter is different here. Namely:

RC-GND = GND -> connect it to GND on the usb-ttl adapter

RC-1 = Uart1-Tx -> connect it to Rx on the usb-ttl adapter

RC-2 = Uart1-Rx -> connect it to Tx on the usb-ttl adapter