Docu for Gimbal24 board(s): Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| (5 intermediate revisions by the same user not shown) | |||
| Line 3: | Line 3: | ||
== Dos and Don'ts == | == Dos and Don'ts == | ||
Please read the tutorial's [[ | Please read the tutorial's [[Dos and Don'ts]]. | ||
== Shop Link == | == Shop Link == | ||
| Line 18: | Line 18: | ||
* I2C#2 plug type: picoblade (1.25mm JST) | * I2C#2 plug type: picoblade (1.25mm JST) | ||
* pin headers: no | * pin headers: no | ||
comes flashed with latest firmware and with configured bluetooth module | |||
Included accessories: | |||
* none | |||
Points to note: | |||
* comes flashed with latest firmware and with configured bluetooth module | |||
* in addition to the board one needs to get a IMU module plus cable&plug (camera IMU) | |||
== Specifications == | == Specifications == | ||
Latest revision as of 19:54, 8 January 2015
This page provides documentation for the STorM32-BGC board sold by Gimbal24.
Dos and Don'ts
Please read the tutorial's Dos and Don'ts.
Shop Link
Board Configuration
- board version: v1.3
- board color: black
- motor drivers in DFN packages: yes
- on-board MPU: yes
- on-board bluetooth module: yes
- I2C plug type: picoblade (1.25mm JST)
- I2C#2 plug type: picoblade (1.25mm JST)
- pin headers: no
Included accessories:
- none
Points to note:
- comes flashed with latest firmware and with configured bluetooth module
- in addition to the board one needs to get a IMU module plus cable&plug (camera IMU)
Specifications
- supply voltage: 6 - 18 V or 2 - 4S
- motor current: max. 1.5 A per motor
Comment: This is not yet fully exploited, motors with resistances of 12 Ohm or larger have been tested to be well handled at 4S (see here, here), motors with 10 Ohm may be handled with care (see here and here). - board dimensions: 50 mm x 50 mm, 45 mm bolt to bolt, holes Ø3 mm
Pins and Connectors
Flashing Firmware
Follow the instructions for v1.3 boards in the How to flash firmware manual.
