View source for Where to get NT Modules

Pre-assembled, ready-to-use NT modules are currently not available commercially. However, the CC3D Atom can easily be used as a NT Imu module, and may be the best choice currently, if DIY is not an option.

== CC3D Atom ==

The [https://www.openpilot.org/openpilot-atom/ Open Pilot CC3D Atom] can be used as NT imu module, when flashed with the respective NT firmware. With the pin headers stripped off, it is also relatively small. 

The Mini CC3D is even smaller, without the need of hardware modifications. Unfortunately it can be first-time flashed only via SWD, and a ST-Link programmer is additionally needed for converting it into a NT module. 

Both boards are available cheaply from various Asian sources, and of course also at somewhat higher prices in many "regular" shops.

Some links:
* [http://www.banggood.com/OpenPilot-CC3D-Atom-Mini-CC3D-FPV-Flight-Controller-CC3D-EVO-p-970762.html CC3D Atom @ banggood]
* [http://www.goodluckbuy.com/openpilot-mini-cc3d-atom-nano-cc3d-side-pin-flight-controller-for-fpv-qav-250-400-quadcopter-.html CC3D Atom @ goodluckbuy]
* [http://www.aliexpress.com/wholesale?catId=0&initiative_id=SB_20150822235223&isPremium=y&SearchText=openpilot+cc3d+atom CC3D Atom @ aliexpress]
* [http://www.goodluckbuy.com/mini-cc3d-32-bit-openpilot-open-source-flight-controller-processor-with-case.html Mini CC3D @ goodluckbuy]
* [http://www.banggood.com/Openpilot-MINI-CC3D-NANO-Atom-Flight-Controller-for-QAV250-Multicopter-250-Frame-Kit-p-992324.html Mini CC3D @ banggood]

== Cables and Connectors ==

Unfortunately I don't know about a cheap and readily available source of suitable pre-configured cables with plugs. The 1 mm JST has however become kind of a standard in the RC world, and used for e.g. flight controllers, gimbal controllers, etc., which gives options.
 
Some options:
* ReadyToFlyQuads/witespy: [http://www.readytoflyquads.com/cables]. Explore the shop carefully and study the various options for configuration which are offered, with the right clicks it actually has some good deals.
* Viacopter: [https://www.viacopter.eu/multirotor-shop/accessories/connectors-and-wires]
* Goodluckbuy: [http://www.goodluckbuy.com/bgc-2-0-brushless-gimbal-driver-sensor-connection-cable-for-gimbal-controller.html]. The silicon wires are not as flexible as for other imu module wires, but in lack of better options OK. Quite expensive.
* Flyduino: [http://flyduino.net/Brushless-Gimbal-Kamerastabilisierung]