NT Camera

From STorM32-BGC Wiki
Revision as of 08:29, 26 April 2016 by OlliW (talk | contribs)
Jump to navigation Jump to search

Since firmware version v2.04e NT camera modules are supported.

The NT camera module allows to remote control a camera. It thus serves a similar purpose as the various RC camera remote control modules, such as e.g. CAMremote and many others. Instead of listening to a servo RC signal however it listens to the info on the NT bus. It is thus usually connected to the NT bus near the camera NT IMU module, which yields extremely slim wiring schemes (see also here). The behavior of the


Currently, dedicated NT camera hardware has not yet emerged, but the NT camera function is also integrated in the NT IMU firmware. This means that those NT IMU modules which expose extra pins can simultaneously be used also as NT camera modules. Specifically we are talking about the "big" NT IMU module and the CC3D Atom based modules.

The details will likely change in future, to accommodate new needs.

In v2.05e three signals are provided on the NT IMU modules at three pins, namely

  • IRCamera: standard servo PWM signal (with ca. 60Hz frequency)
  • IRCamera: 50 ms off/on/off pulse
  • PWM Out: standard servo PWM signal (with ca. 60Hz frequency)