STorM32 Boards: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 7: | Line 7: | ||
== STorM32-BGC v1.2 == | == STorM32-BGC v1.2 == | ||
[[File:Storm32 bgc v120 board dfn mpu-01-wp01.jpg|thumb|caption| | [[File:Storm32 bgc v120 board dfn mpu-01-wp01.jpg|thumb|caption|STorM32 BGC board v1.2]] | ||
* MCU: STM32F103RC | * MCU: STM32F103RC | ||
Revision as of 18:22, 20 February 2014
Currently, three different versions of STorM32-BGC boards are around.
Comment: The boards can in principle be populated with different microcontrollers, but below the "typical" configuration is mentioned.
STorM32-BGC v1.2
- MCU: STM32F103RC
STorM32-BGC v1.1
- MCU: STM32F103RC
Comments:
- The order of pins on the I2C#2 port is reversed to that on the I2C#1 port; please consider this then connecting an MPU module to this port.
STorM32-BGC v0.17/v1.0
- MCU: STM32F103RB
Comments:
- The location of the pins needed to flash the firmware via an USB-TTL adapter is different here. Namely:
- RC-GND = GND -> connect it to GND on the usb-ttl adapter
- RC-1 = Uart1-Tx -> connect it to Rx on the usb-ttl adapter
- RC-2 = Uart1-Rx -> connect it to Tx on the usb-ttl adapter