STorM32 Boards: Difference between revisions

Revision as of 18:16, 20 February 2014

Currently, three different versions of STorM32-BGC boards are around.

Comment: The boards can in principle be populated with different microcontrollers, but below the "typical" configuration is mentioned.

Comments:

The order of pins on the I2C#2 port is reversed to that on the I2C#1 port; please consider this then connecting an MPU module to this port.

Comments:

The location of the pins needed to flash the firmware via an USB-TTL adapter is different here. Namely:

RC-GND = GND -> connect it to GND on the usb-ttl adapter

RC-1 = Uart1-Tx -> connect it to Rx on the usb-ttl adapter

RC-2 = Uart1-Rx -> connect it to Tx on the usb-ttl adapter

Revision as of 18:15, 20 February 2014 (view source) OlliW (talk \| contribs) No edit summary ← Older edit		Revision as of 18:16, 20 February 2014 (view source) OlliW (talk \| contribs) No edit summary Newer edit →
Line 9:		Line 9:
	* MCU: STM32F103RC		* MCU: STM32F103RC

	[[~~File:~~File:Storm32 bgc v120 board dfn mpu-01-wp01.jpg]]		[[File:Storm32 bgc v120 board dfn mpu-01-wp01.jpg]]