STorM32 Boards: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
|||
Line 10: | Line 10: | ||
[[File:Storm32 bgc v120 board dfn mpu-01-wp01.jpg|thumb|caption|STorM32 BGC board v1.2]] | [[File:Storm32 bgc v120 board dfn mpu-01-wp01.jpg|thumb|caption|STorM32 BGC board v1.2]] | ||
{| | {| | ||
|* MCU: STM32F103RC | | | ||
* MCU: STM32F103RC | |||
* Motor drivers: TC4452VMF | * Motor drivers: TC4452VMF | ||
* on-board Bluetooth (optional) | * on-board Bluetooth (optional) | ||
Line 25: | Line 26: | ||
* voltage: max. 18 V or 4S | * voltage: max. 18 V or 4S | ||
|} | |} | ||
== STorM32-BGC v1.1 == | == STorM32-BGC v1.1 == |
Revision as of 12:20, 22 February 2014
At present, three different versions of STorM32-BGC boards are around.
Comments:
- The boards can in principle be populated with different microcontrollers; below the "typical" configuration is mentioned.
- To avoid confusion/missunderstandings please note: The boards provide many features hardware-wise, but not all are however currently supported by the firmware.
STorM32-BGC v1.2
|
|
STorM32-BGC v1.1
differences to the v1.2 board:
- no Futaba S-bus support
- Spektrum satellite is supported, but no extra Spektrum connector on board
Comments:
- The order of pins on the I2C#2 port is reversed to that on the I2C#1 port; please consider this then connecting an MPU module to this port.
STorM32-BGC v0.17/v1.0
- MCU: STM32F103RB
Comments:
- The location of the pins needed to flash the firmware via an USB-TTL adapter is different here. Namely:
- RC-GND = GND -> connect it to GND on the usb-ttl adapter
- RC-1 = Uart1-Tx -> connect it to Rx on the usb-ttl adapter
- RC-2 = Uart1-Rx -> connect it to Tx on the usb-ttl adapter