STorM32 Boards: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 27: | Line 27: | ||
'''Comments:''' | '''Comments:''' | ||
* The location of the pins needed to flash the firmware via an USB-TTL adapter is different here. Namely: | * The location of the pins needed to flash the firmware via an USB-TTL adapter is different here. Namely: | ||
:RC-GND = GND -> connect it to GND on the usb-ttl adapter | |||
:RC-0 = Uart1-Rx -> connect it to Tx on the usb-ttl adapter | |||
:RC-1 = Uart1-Tx -> connect it to Rx on the usb-ttl adapter | |||
Revision as of 15:52, 20 February 2014
Currently, three different versions of STorM32-BGC boards are around.
Comment: The boards can in principle be populated with different microcontrollers, but below the "typical" configuration is mentioned.
STorM32-BGC v1.2
- MCU: STM32F103RC
STorM32-BGC v1.1
- MCU: STM32F103RC
Comments:
- The order of pins on the I2C#2 port is reversed to that on the I2C#1 port; please consider this then connecting an MPU module to this port.
STorM32-BGC v0.17/v1.0
- MCU: STM32F103RB
Comments:
- The location of the pins needed to flash the firmware via an USB-TTL adapter is different here. Namely:
- RC-GND = GND -> connect it to GND on the usb-ttl adapter
- RC-0 = Uart1-Rx -> connect it to Tx on the usb-ttl adapter
- RC-1 = Uart1-Tx -> connect it to Rx on the usb-ttl adapter