STorM32 Boards: Difference between revisions
Jump to navigation
Jump to search
| Line 24: | Line 24: | ||
* BUT port | * BUT port | ||
| | | | ||
* voltage: 5 - 18 V or 2 - 4S | * supply voltage: 5 - 18 V or 2 - 4S | ||
* motor current: max. 1.5 A per motor<br/> note: this is not yet fully exploited and depends also on the motor driver package (SOIC or DFN) <br/> with the DFN packages, motors with resistances of 15 Ohm or larger have been tested to be easily handled at 4S, it is expected that also motors with 10 Ohm or larger are handled well (for more details see [//www.rcgroups.com/forums/showthread.php?t=2055844&page=2&pp=50#post27515444 here]). | * motor current: max. 1.5 A per motor<br/> note: this is not yet fully exploited and depends also on the motor driver package (SOIC or DFN) <br/> with the DFN packages, motors with resistances of 15 Ohm or larger have been tested to be easily handled at 4S, it is expected that also motors with 10 Ohm or larger are handled well (for more details see [//www.rcgroups.com/forums/showthread.php?t=2055844&page=2&pp=50#post27515444 here]). | ||
|} | |} | ||
Revision as of 00:20, 5 March 2014
At present, three different versions of STorM32-BGC boards are around.
Comments:
- The boards can in principle be populated with different microcontrollers; below the "typical" configuration is mentioned.
- To avoid confusion/missunderstandings please note: The boards provide many features hardware-wise, but not all are however currently supported by the firmware.
STorM32-BGC v1.2
|
|
STorM32-BGC v1.1
Differences to the v1.2 board:
- no Futaba S-bus support
- Spektrum satellite is supported, but no extra Spektrum connector on board
- no extra USB voltage protection diode
Comment: The order of pins on the I2C#2 port is reversed to that on the I2C#1 port; please consider this then connecting an MPU module to this port.
STorM32-BGC v0.17/v1.0
Differences to the v1.2 board:
- MCU: STM32F103RB
- motor drivers: only TC4452VAO in SO08 package
- no IR led support
- only three PWM/Sum-PPM inputs/outputs
- no Futaba S-bus support
- Spektrum satellite can be supported, but no extra Spektrum connector on board
- no additional I2C port
- no reverse voltage protection on the v0.17 board
- pin assignment on RC port different
Comment: The location of the pins needed to flash the firmware via an USB-TTL adapter is different here. Namely:
- RC-GND = GND -> connect it to GND on the usb-ttl adapter
- RC-1 = Uart1-Tx -> connect it to Rx on the usb-ttl adapter
- RC-2 = Uart1-Rx -> connect it to Tx on the usb-ttl adapter