STorM32 Boards: Difference between revisions
| Line 9: | Line 9: | ||
In addition to the boards shown here, also other variants exist, such as e.g. micro versions. | In addition to the boards shown here, also other variants exist, such as e.g. micro versions. | ||
Design schemes are located in https://github.com/olliw42/storm32bgc. | |||
=== STorM32-BGC v6.3 === | === STorM32-BGC v6.3 === | ||
Revision as of 13:00, 18 November 2025
"Original" STorM32 Boards
At present, board versions v6.x are supported (v0.17/v1.0, v1.1, v1.2, v1.3x, v2.4, v3.3, v4.1 boards are not supported).
The STorM32 boards offer two types of NT bus ports, the NT and NT-X ports. They both are different from the NT bus connectors on the NT modules in that they have swapped Rx, Tx pins.
Comment: The Rx, Tx pins of the NT and NT-X ports on the STorM32 board must be connected to the Tx, Rx pins on the NT modules.
In addition to the boards shown here, also other variants exist, such as e.g. micro versions.
Design schemes are located in https://github.com/olliw42/storm32bgc.
STorM32-BGC v6.3
|
|
Comment: This board is design of Gohstand Designs and based on the v4.1 design of KrattWorks.
The JP1 solder bridge is on the bottom side of the board. When closed: The motor drivers are connected to VBat and functional. The voltage shall then not exceed 12 V or 3S. When open: The motor drivers are disabled and non-functional; the voltage can then be up to 27 V or 6S.
STorM32-BGC v6.2
|
|
Comment: This board has no motor drivers; NT motor modules are thus mandatorily required.
