Dos and Don'ts: Difference between revisions
Jump to navigation
Jump to search
m (OlliW moved page Dos and Dont's to Dos and Don'ts) |
No edit summary |
||
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
The STorM32 | The STorM32 gimbal controller is an electronic device. | ||
This should have said it all, yet some specific don'ts: | This should have said it all, yet some specific don'ts: | ||
| Line 15: | Line 15: | ||
* {{WARNING|'''Do not power anything from the 3.3 V power rail except of the intended items'''}} (camera IMU, 2nd IMU, Spektrum satellite, joystick, IR led). | * {{WARNING|'''Do not power anything from the 3.3 V power rail except of the intended items'''}} (camera IMU, 2nd IMU, Spektrum satellite, joystick, IR led). | ||
* | * On some boards the motor drivers are not short-circuit protected. It is recommended for new/unknown motors to measure the resistances of the motor phases and to the motor housing before the they are connected to the board. | ||
Latest revision as of 08:45, 5 May 2018
The STorM32 gimbal controller is an electronic device.
This should have said it all, yet some specific don'ts:
- Do not get any parts of the board into contact with the (plus pole of the) battery, this will immediately destroy the board.
- The voltage on the POT and BUT pins must not exceed 3.3 V, else the board will be immediately destroyed.
- The voltage on any of the other pins must not exceed 5 V, else the board will be immediately destroyed.
- The 3.3 V pins on the board should only be used as supply. Do not apply voltage to a 3.3 V pin. Do not connect a 3.3 V pin to a GND pin.
- Do not use metal screws to mount the board. This can lead to short circuits. At the very least use plastic washers.
- Do not power anything from the 3.3 V power rail except of the intended items (camera IMU, 2nd IMU, Spektrum satellite, joystick, IR led).
- On some boards the motor drivers are not short-circuit protected. It is recommended for new/unknown motors to measure the resistances of the motor phases and to the motor housing before the they are connected to the board.