RS485, LVDS, and Alike: Difference between revisions
Jump to navigation
Jump to search
No edit summary |
No edit summary |
||
| Line 19: | Line 19: | ||
For discussions see [https://www.rcgroups.com/forums/showthread.php?2838548-T-STorM32-The-best-STorM32-ever-%21/page29&perpage=50#post42574563 here] and follow up posts. | For discussions see [https://www.rcgroups.com/forums/showthread.php?2838548-T-STorM32-The-best-STorM32-ever-%21/page29&perpage=50#post42574563 here] and follow up posts. | ||
:[[File:Storm32-nt-rs485-lvds-and-alike.jpg| | :[[File:Storm32-nt-rs485-lvds-and-alike.jpg|560px]] | ||
Revision as of 09:43, 3 September 2019
The information on this page refers to firmware v2.43 and higher.
The STorM32 controller supports using RS485, Low Voltage Differential Signaling (LVDS), or other bus drivers for its NT bus.
For that purpose the NT modules provide two pins, one active HIGH and one active LOW, which allow us to enable/disable the respective transmit port drivers on the NT module.
| NT Module | active HIGH pin | active LOW pin |
|---|---|---|
| NT Imu v2.x | PA0 | PA15 |
| NT Motor v2.x | PA0 | PA15 |
| NT Logger v1.x | PA0 | PA15 |
For discussions see here and follow up posts.
